Maintenance and Cleaning | Water Baths

🔍 Need More Information?

📂 Getting Started

📦 Setup & Installation

⚙️ Operating Procedures

🔧 Troubleshooting & Repair

📜 Warranty & Support

General Cleaning Instructions

• Interior and Exterior: Clean with a soft cloth and soapy water as needed. Avoid abrasive cleaners or scouring pads, as they may scratch the surface and cause corrosion. Do not use caustic cleaning agents.

• Electrical Components: Do not expose any electrical parts to moisture.

NOTE: Always switch the bath off and unplug it from the power source before cleaning. 

Cleaning Stainless Steel

Stainless steel is generally resistant to corrosion, but some chemicals and a lack of oxygen can cause rust or pitting. When routine cleaning, avoid deionized water and use water that meets the suggested quality requirements in the water quality section. Use a damp cloth for everyday cleaning, and avoid harsh chemicals.

Draining

The bath has a built-in dry-break drain.

Before emptying the bath:

• Disconnect the device from the power supply and remove the plug.
• Allow the water temperature to fall to a safe level.
• Take reasonable precautions to prevent accidental spillage.

The drainage operation is as follows:

1. Insert the drain pipe into the drain port according to the direction shown in the figure
   (1) Drain Pipe; (2) Drain Port
2. After draining, loosen the lock of the drain port in the direction of the arrow as shown in the figure, then quickly pull out the drain pipe.