Applicable Models:
📜 Quick Navigation
🔍 Need More Information?
📂 Getting Started
📦 Setup & Installation
⚙️ Operating Procedures
🔧 Troubleshooting & Repair
📜 Warranty & Support
General Cleaning Instructions
-
Clean with a soft cloth and soapy water as needed. Avoid abrasive cleaners or scouring pads, as they may scratch the surface and cause corrosion. Do not use caustic cleaning agents.
- Electrical Components: All heater circulators contain electrical components, such as the temperature control and internal light. These components should not be exposed to any moisture.
- Always switch off the heater circulator and unplug it from the power supply before cleaning.
- A cleaning reminder will appear on the screen after 20 cycles or 100 hours of operation.
- To reset the reminder, run a cleaning cycle by turning the heater circulator on and simultaneously pressing the Start/Stop button (Button 3) and the Decrease button (Button 5). This will set the temperature to 80°C and the time to 3 hours. The settings will flash 10 times, and once they stop flashing, press the Start/Stop button to begin the cleaning process. The heater circulator will beep when the cleaning cycle is complete.
Cleaning Stainless Steel
Stainless steel is generally resistant to corrosion, but some chemicals and a lack of oxygen can cause rust or pitting. When routine cleaning, avoid deionized water and use water that meets the suggested quality requirements in the water quality section. Use a damp cloth for everyday cleaning, and avoid harsh chemicals.
Antimicrobial Additive for Heating Bath Fluids
Use an antimicrobial additive designed for use in water-soluble heating bath fluids to maintain cleanliness and prevent contamination.
Features:
- Effective Against:
- Bacteria
- Enveloped viruses
- Algae
- Fungi
- Additional Benefits:
- Inhibits the precipitation of inorganic salts, ensuring consistent bath performance.